Jump to content

Equipment Use and Repair

Use and maintenance of kilns, wheels, pug mills, slab rollers, etc. 
Moderated by: Neil Estrick

3,288 topics in this forum

  1. Help With AIM Automatic Kiln Switch

    By birdlaw,
    • 10 replies
    • 755 views

  2. The Clay Boss Wobble

    By Ja.Sc.,   
    • 10 replies
    • 1.6k views

  3. Another Duncan Ea820-2 Kiln Question(s)

    By artteachrm,   
    • 3 replies
    • 584 views

  4. Brand New Skutt 818 Kiln floor crack

    By baby-egg,
    • 3 replies
    • 475 views

  5. Old Brent Pottery Wheel

    By Peter Dickson,   
    • 14 replies
    • 7.2k views

  6. Jigger and jolly Mould

    By Prateek,   
    • 9 replies
    • 2.5k views

  7. Firing sheeps fleece wool in foil saggar

    By Emma Law,
    • 5 replies
    • 731 views

  8. Skutt 614-3 kiln

    By LisaDBJ,
    • 7 replies
    • 1.1k views

  9. S-type thermocouple

    By Dick White,
    • 8 replies
    • 531 views

  10. plaster wedging table repair

    By Viki,   
    • 6 replies
    • 1.6k views

  11. New Kiln Advice

    By Skip,
    • 12 replies
    • 652 views

  12. Best kiln brand?

    By Jeanetta,
    • 8 replies
    • 1.2k views

  13. Time/cost estimate for replacing kiln elements?

    By JRW,
    • 5 replies
    • 881 views

  14. Kiln Size Question

    By kre8ivLizard,
    • 10 replies
    • 1.2k views

  15. Carbon Monoxide - Electric and Gas Kilns

    By Min,
    • 1 reply
    • 917 views

  16. Kiln vent setup 1 2 3

    By thiamant,
    • 52 replies
    • 2.9k views

  17. Kiln malfunctioning : Three Kiln “ERR” s in a 17 hour long bisque fire!!

    By Jeanetta,
    • 12 replies
    • 427 views

  18. Electric kiln in an open-front garage

    By David G,
    • 2 replies
    • 143 views

  19. New kiln owner with questions

    By blackthorn,
    • 11 replies
    • 619 views

  20. Portable Wheel for Demo purpose

    By jimfetzer,   
    • 12 replies
    • 537 views

  21. Elements on full Glow when turning kiln on.

    By Kerry S,
    • 4 replies
    • 466 views

  22. Sensing Rod Bent to the side instead of centered

    By littlefairyone,
    • 1 reply
    • 216 views

  23. OLYMPIC GAS 2831 TIP

    By MFP,
    • 1 reply
    • 202 views

  24. Skutt kiln is heating unevenly

    By Ian Bee,
    • 9 replies
    • 1.1k views

  25. low fire SSR + APM upgrade? 1 2

    By bayanMM,
    • 26 replies
    • 1.2k views
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept