Jump to content

Equipment Use and Repair

Use and maintenance of kilns, wheels, pug mills, slab rollers, etc. 
Moderated by: Neil Estrick

3,282 topics in this forum

  1. Help with error message

    By LindaG,
    • 6 replies
    • 561 views

  2. timing a firing on controller

    By oldlady,
    • 4 replies
    • 418 views

  3. Help replacing Hobbytech 40 Energy Regulator

    By Graham G,
    • 5 replies
    • 540 views

  4. Norman Kiln Model 4 Information

    By JoshO,
    • 2 replies
    • 524 views

  5. Kiln proximity to propane heater or garage door

    By Heidi KH,   
    • 2 replies
    • 407 views

  6. From 4 cuft to 12 cuft, finally got a big boy kiln! 1 2 3

    By liambesaw,
    • 60 replies
    • 4.4k views

  7. Another KM1227 question

    By brettwulc,
    • 4 replies
    • 280 views

  8. Need Kiln Burner "Orifice Connector"

    By ThruTraffic,
    • 3 replies
    • 297 views

  9. Bent Bolt on clay boss tension plate

    By Im_ryan_,   
    • 3 replies
    • 331 views

  10. Gare Kiln

    By ClayCreations,   
    • 19 replies
    • 11.5k views

  11. 1227 vent holes not pulling during whole firing

    By brettwulc,
    • 3 replies
    • 268 views

  12. North star tile press

    By Noodles747,
    • 4 replies
    • 550 views

  13. Kiln taking a long time to reach temp with new elements

    By Osso,
    • 11 replies
    • 350 views

  14. My kiln keeps turning off

    By Paolaeffio,
    • 3 replies
    • 391 views

  15. Using angle grinder to remove glaze from a kiln shelf? 1 2

    By thiamant,
    • 26 replies
    • 2.6k views

  16. kiln advice top-loader vs front-loader

    By akilspots,
    • 13 replies
    • 1.5k views

  17. Looking at a used kiln and dont know what to offer

    By Darlene,
    • 1 reply
    • 200 views

  18. Alsager type wheel replacing a drivebelt

    By diddlyzip,
    • 0 replies
    • 138 views

  19. Mercury Relay Replacement Help

    By bayanMM,
    • 4 replies
    • 603 views

  20. Need help fixing the foot pedal of a Creative Industries wheel

    By spring,
    • 1 reply
    • 410 views

  21. New (to me!) kiln needs some help

    By kylies.clay,
    • 4 replies
    • 649 views

  22. Old shimpo wheel stuck in left hand mode

    By PSC,
    • 11 replies
    • 3.3k views

  23. Kiln wall/floor thickness questions

    By AaronRotchadl,
    • 3 replies
    • 594 views

  24. Element pigtail too short

    By Osso,
    • 8 replies
    • 545 views

  25. Crossdraft salt glaze

    By Mirrored-K-Studio,
    • 4 replies
    • 460 views
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept