neilestrick
-
Posts
12,380 -
Joined
-
Last visited
About neilestrick
Recent Profile Visitors
neilestrick's Achievements
Advanced Member (3/3)
7k
Reputation
Single Status Update
See all updates by neilestrick
-
Old Gare Kiln Model 2329A
Had to replace to cord with the proper sized one. But, while doing that one of the element leads on the bottom came loose on the end not attached to the element and i am not sure where it connects back too. I have not been able to find any images for the back of the controller, or a diagram showing how it is wired up.
- Show previous comments 3 more
-
the yellow is where the black goes to the block. does the white lead run the path of the red line or the green line?
-
The wire should have a ring terminal on it if it goes to the block. Check that it didn't pull out of the ring terminal. If it's bare wire it may go to the relay. I'm not familiar with that model so I can't say for sure though.
-
ya i didnt see any empty ring terminals that it could have pulled out of. i was thinking it may have been out of the relay but i am not sure either.
