jrgpots Posted May 10, 2016 Report Share Posted May 10, 2016 Does anyone here have a diagram of the brent slab roller cable system. I want to replace the old cables. The current ones are getting frayed. Jed Link to comment Share on other sites More sharing options...
Mark C. Posted May 10, 2016 Report Share Posted May 10, 2016 Put them together like the are now Pay close attention to how they are warped and how many wraps Never seen a diagram Link to comment Share on other sites More sharing options...
Dick White Posted May 10, 2016 Report Share Posted May 10, 2016 Try this... http://docslide.us/documents/amanco-slab-rollers-manual.html Link to comment Share on other sites More sharing options...
Marcia Selsor Posted May 10, 2016 Report Share Posted May 10, 2016 Make sure you grease them well. I adjusted the tension on the one at the University by plucking the cables until they hit the same note. Worked well. It isn't difficult to replace the cables but I will say the customer service 20 years ago was not very helpful. Marcia Link to comment Share on other sites More sharing options...
Pres Posted May 10, 2016 Report Share Posted May 10, 2016 Replaced them in the HS twice. It was a pain, but one thing is for certain-not greasing is a major mistake. Original set was not grease, and I did not grease. Learned my lesson as it went out after two years. After replacing and the pain of that, I made certain to grease. This allowed them to last many many years with greasing and adjustment each year.. best, Pres Link to comment Share on other sites More sharing options...
neilestrick Posted May 10, 2016 Report Share Posted May 10, 2016 If you buy the cable from Brent they will come with a diagram. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.