-
Posts
2,208 -
Joined
-
Last visited
Reputation Activity
-
Hulk reacted to WRS in Does anyone know where we can get our hands on a user manual for a kiln that has been
Yes, in Hurstville south area of Sydney. But its OK now. We just got a manual sent from A.A Kilns who have a lot of manuals. Cheers Stuart!
-
Hulk got a reaction from Pres in Way to go @Hulk ! I've enjoyed your insights from that "Pile 'o sand" in southern CA.
Thanks JohnnyK!
I'm enjoying your contributions to the Forum as well, keep it rolling!
-
Hulk reacted to Victoria Fallon in black clay
Is anyone working with B3 clay? its a beautiful chocolate brown and fires black. it has a a lot of manganese and iron in it and can eat up color. TEST, test and test some more.
-
Hulk reacted to Min in Just had spine surgery so I'll be off the wheel for a month or two, but will still ke
Speedy recovery!
-
Hulk got a reaction from Min in Hi everyone! New to the site and looking for advice please. I have just bought an old
Hi Hivvie!
You might get more responses by posting to the forum topic for equipment.
If you can also post a picture of the kiln and thermocouple, that might help.
-
Hulk got a reaction from Soup in Hello, I was wondering if I have a kiln that goes up to cone 6 as the max then would
Hi Soup!
Perhaps you might move your question to Studio Operations and Making Work topic - might generate some discussion there.
Typically, new kiln will be able to reach its max rating, but at cost of more rapid wear on the elements; for cone 6 work, a kiln rated for cone 10 would be more suitable.
-
Hulk got a reaction from Pres in New kiln was shipped today.
Good-oh!
Hope you thoroughly enjoy your journey to modern kiln land Pres.
-
Hulk got a reaction from terrim8 in I burnt hand in the kitchen again! I'm getting a set of protective raku style gear fo
Hope you feel bettrsoon terrim!
...soak that pot, soak it goood
-
-
Hulk reacted to Bill Kielb in Hi Donna! May I suggest you post your question to the "Studio Operations and Making W
The v6CF defaults to about 120 degrees per hour in the last 250 degrees of firing in cone fire mode. so their built in cone table will say 2232 I believe. I just replied with a post detailing some simple questions and we can send her the basic V6Cf technical setup. It’s pretty easy and since she is close likely will help correct the situation.
she will need to get familiar with fast glaze, slow glaze, etc..... as well
-
Hulk reacted to Min in Back to work for two weeks then a new hip for my wife-two weeks off for me then to ca
Best wishes to your wife for a speedy recovery.