Just got this kiln from school district auction

[Dmonclova]

Hi just had some questions on this kiln since I can't find a manual or anything online given the serial number. Also any tips on transporting it would be great? Not sure if comes apart like the newer models. 

[neilestrick]

You'll have to take off the control box to get it apart, but then you can move the upper and lower sections separately, which will be much easier and safer than trying to move it all at once. Just label the wires as you unhook them so you can put it back together properly. Set it on a piece of foam when you move it so you don't break the bricks. House insulating foam board works fine. Did they include the stand? If not, buy one or use cinder blocks.

HERE is the manual. Most all manual kilns work the same. Set up the Sitter with the proper cone, then do 1 hour with all switches on low, 1 hour on medium, then high until the Sitter shuts it off.  Set the Sitter timer to about 1/2 hour longer than you expect the firing to take (you'll have to do a firing to figure that out).

I assume this is going in your home? That kiln currently has elements for 208 volt electrical service. In order to use it at your house you'll need to change them to 240 volt elements. The amperage draw will probably be slightly lower with the new elements, but it will probably need a 60 amp circuit. Call Paragon for elements and to confirm the amperage draw. Kilns must be on a breaker that is 25% greater than the draw of the kiln. If Paragon's elements are pricey, also try Euclids.com.

[Pres]

All too often a school kiln bargain ends up a bit of a headache as most are 208. However, it looks to be in good shape, and the change of elements even though time consuming and requires care is not difficult.

 

best,

Pres