Barbsbus 4 fun Posted August 26, 2020 Report Share Posted August 26, 2020 I have been given some kiln shelves and spacers that were wrapped in newspaper, then stored in plastic tub outside and the lid of the tub cracked and water got into the tub and was in there for months. When found everything was full of mold. I have dried all of the pieces in the sun but I think I need to clean them some how. How should I go about it? Link to comment Share on other sites More sharing options...
Sorcery Posted August 26, 2020 Report Share Posted August 26, 2020 I would just throw em on a really slow burn cycle. But ...... I might decide getting new ones is better. That could be quite the explosion. Sorce Link to comment Share on other sites More sharing options...
Bill Kielb Posted August 26, 2020 Report Share Posted August 26, 2020 4 hours ago, Barbsbus 4 fun said: How should I go about it? I would bisque fire them at this point with a long hold at 200 to make sure they were completely dry. Maybe 1 hour to 200 then bisque to 06 I would think is more than enough. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.