High Bridge Pottery
-
Posts
2,562 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Everything posted by High Bridge Pottery
-
From the album: Test
-
Finally going to be firing with my power burner tomorrow, had a month with no free time at all
let's hope it works.- Show previous comments 8 more
-
Had it open and I managed to crack about 25% of the pots. It did go from room temp to 400c in 30 min on the lowest setting. I need a smaller burner for the very start I think. All cone 9's and 10's down except right at the flue where cone 10 was starting to go.
-
stinks about the pots cracking but part of testing! how did the ones that didn't crack turn out? Wonderful stuff? You will figure out the firing stuff, look how far you have came!
-
Joel- consider yourself a Trekkie- boldly going where no potter has gone before.
-
From the album: Test
-
Packed up and delivered about 350 pots.
- Show previous comments 3 more
-
Such a good feeling:)
-
May your orders increase and your glaze never run. Mail going out next week.
-
Sweet
I am excited. I will have to make some spare time when it arrives.
-
From the album: Test
-
image1 (1)
High Bridge Pottery commented on High Bridge Pottery's gallery image in Browse Member Galleries
Thank you I think I have been annoying the local welder with this project. I am very happy with how well it turned out. 100% better than I thought it would. -
From the album: Kiln
-
Thrown work.
Images added to a gallery album owned by High Bridge Pottery in Browse Member Galleries
-
-
From the album: Thrown work.
-
From the album: Test Tiles
-
I love your work, is it slip and stencils that you use? -
From the album: Kiln
-
From the album: Test
-
From the album: Kiln
-
From the album: Kiln
-
From the album: Kiln
-
image2 (5)
High Bridge Pottery commented on High Bridge Pottery's gallery image in Browse Member Galleries
Thanks I haven't made it that far yet, still need to work out what I am going to use for the forced air and probably sort out a flame failure valve. After that it should be go for testing. -
From the album: Kiln
-
From the album: Kiln
-
Two more parts to be delivered then my forced air burner will be in nearly working condition
- Show previous comments 1 more
-
I hope this makes the kiln work otherwise I am at another dead end. Dad thinks I am going to blow up his garage, not so happy xD
-
lol..
-
Adversity is the mother of learning. Stay with it. HVD
-
From the album: Glaze Chemistry
-
From the album: Kiln
-
IMG 0665
High Bridge Pottery commented on High Bridge Pottery's gallery image in Browse Member Galleries
I have been meaning to go through my galleries explaining a little better never happened yet. This is my kiln controller prototype, the little box with wires going to the breadboard is a small 5v relay that I can turn on and off with the computers power. That small relay is then switching a 12v line to turn on and off the big relay which controls the kiln power. You can see the four terminals that wires would be connected to (nothing connected on this picture) -
IMG 0666
High Bridge Pottery commented on High Bridge Pottery's gallery image in Browse Member Galleries
If only it worked! Fired twice and stalled out at 1000c. Not getting anywhere near enough oxygen. Looking into power burners now to solve that problem. -
From the album: Kiln
let's hope it works.
I am excited. I will have to make some spare time when it arrives. 
