Polyhedron Posted June 27, 2019 Report Share Posted June 27, 2019 Are these made with slip casting? How do they make holes like that? Link to comment Share on other sites More sharing options...
liambesaw Posted June 27, 2019 Report Share Posted June 27, 2019 Probably slip cast, but still need to cut with a scalpel or xacto Link to comment Share on other sites More sharing options...
Polyhedron Posted June 29, 2019 Author Report Share Posted June 29, 2019 On 6/27/2019 at 10:33 PM, liambesaw said: Probably slip cast, but still need to cut with a scalpel or xacto Do they use a sort of template for cutting? Or do they just do it by eye? Link to comment Share on other sites More sharing options...
liambesaw Posted June 29, 2019 Report Share Posted June 29, 2019 There would be indents in the slip casting that would guide you. Otherwise just draw a pattern and cut it out. Link to comment Share on other sites More sharing options...
Callie Beller Diesel Posted June 30, 2019 Report Share Posted June 30, 2019 I imagine the rounder shapes were probably sketched out and done freehand. The pieces could have been thrown and had those openings sketched out and then cut. Link to comment Share on other sites More sharing options...
JohnnyK Posted June 30, 2019 Report Share Posted June 30, 2019 If you look at the bottom part of the front most vase in the second pic, you can see indentations in the surface. The slip cast piece probably has those indentations which can be used as a guide for making the cutouts. That is how I would do it... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.