Teri Cleverly Posted May 1, 2018 Report Share Posted May 1, 2018 We have a skutt kiln in our art studio. I am changing the thermocouple out today and am relatively new to kiln work. Our amaco glazes fired at cone 6 at a medium firing isn't allowing our glazes to completely melt. Should I try cone 5 glaze firing on slow mode to help the glazes mature better? Link to comment Share on other sites More sharing options...
Marcia Selsor Posted May 1, 2018 Report Share Posted May 1, 2018 are you holding at ^6 for 20 minutes or so? Link to comment Share on other sites More sharing options...
neilestrick Posted May 1, 2018 Report Share Posted May 1, 2018 Does the controller say it's a complete firing? If the controller is happy, but the temperature isn't there, it's probably the thermocouple. Link to comment Share on other sites More sharing options...
Min Posted May 1, 2018 Report Share Posted May 1, 2018 I'ld put cone packs in so you can see if you are hitting cone 6 or 5 or ? Welcome to the forum Link to comment Share on other sites More sharing options...
arbust91 Posted May 2, 2018 Report Share Posted May 2, 2018 I have been using some Amaco glazes lately that say Cone 5 or to cone 6. I'm getting good maturity at cone 5 with a slow cool ( just to 1950F ). cone 6 is fine with no hold at all but got a few pin holes possibly from only bisque to 06 instead of 04 ( I'm bisque firing to 04 now with a 10 min hold on VERY densely stacked loads. My pyrometer is the old metal kind and is still very accurate, I have mostly stopped using cones and look at the heat work via math rather than cones. Its just a ratio anyway. if you can get the relationship of how heat work is a function the cones don't matter. Link to comment Share on other sites More sharing options...
clay lover Posted May 3, 2018 Report Share Posted May 3, 2018 What do the witness cones look like? That's where the truth is. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.