Pugmill Won't Extrude Posted May 1, 2019 Report Share Posted May 1, 2019 Hello! I recently purchased a Peter Pugger VM70 and it pugs great until I assemble the extrusion dies to the end. I follow the same directions as for pugging and nothing comes out with the dies. This is so frustrating! Thanks for any advice. Link to comment Share on other sites More sharing options...
Mark C. Posted May 1, 2019 Report Share Posted May 1, 2019 Welcome to the foruem You must mean the VM7 thats a small(baby size) machine so make sure the machine is packed FULL of clay (all 14#s) and thats its firm enough to not be spining in barrel(not to wet) Let us know if this helps Link to comment Share on other sites More sharing options...
neilestrick Posted May 1, 2019 Report Share Posted May 1, 2019 Depending on the size of the die, you may need your clay to be softer. Link to comment Share on other sites More sharing options...
Mark C. Posted May 2, 2019 Report Share Posted May 2, 2019 Small dies need soft clay super soft of clay will spin in the machine and not create back pressure to go out. whjat size is the hole in die? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.