Nawaf

Im so excited for the kiln that i didn’t even check mains fuse before posting this question found one fuse blowin, I’ll replace and i hope its will work this time

Thank you Peter

Thank you Peter

Second post about this kiln, After managing to connect all the wires and replace the thermocouple and bought new controller only the red light working but nothing else, i have checked the contactor (i hope this its name), and its not turning on always on 0, i have tested continuity of all wires and all fine, and i have tested the ohm resistance of the contactor and its fine, kindly advise, Solved: found one of the mains fuses are blown, replaced it and finally the kiln is working fine

It’s clear, but do you know if it’s ok to use 40amp breaker instead of 10amp as suggested, i have 40amp installed in the panel and im planning to replace it with 10amps

Unfortunately been one month without reply from Potterycrafts, so i have to figure it out myself, this is what i thought about the wiring, I’ll wire it to 3 phase, Thank you for your reply

Thank you for your reply the single phase is 32amp and 3 phase is 10amp, but i was wondering which one is better for the kiln or both have the same results for the kiln

I have contacted them 6 days back but unfortunately there is no reply, can’t wait to start my new journey i was hoping to find the help here in the community

I can’t find which thermocouple exactly i have to order from the manual, but i have measured the length it’s around 125mm,

Thank you for your reply, I actually reconnected controller socket wires, and i find out how to connect mains, kindly check the pictures and correct me if I’m wrong, if i want 3 phase i need to connect as the diagram but there is 250v fuse or something which single phase voltage do i need to remove it ? and if i want to connect single phase i connect ground to green and black to neutral and the red to one of L1 L2 L3 but i was wondering if there is any advantage of 3 phase over single phase, i have the ability to connect either only extra cost for 3 phase cable from the DP,

Hello potters, first time posting, bought a second hand potterycrafts p5975 but from the look and furniture i think its new and the the first owner tried to convert it to a manual kiln with no luck, i have no experience with kilns and this is my first kiln kindly help me to get back to life, 1-the wires of the controller has been cut and connected directly to power source, i want to reconnect all the wires into original places but i don’t want to connect something wrong and miss up the kiln 2-the thermocouple is broken, tried to order new one from potterycrafts but there is a lot of options and I don’t know which one fits my kiln, 3-the controller is missing and im planning on ordering cera10 from potterycrafts but i was wondering if i can find used one for lower price or better options from cera controller, Thank you in advance