fergusonjeff Posted May 8, 2019 Report Share Posted May 8, 2019 One secret to getting plaster to stick to the batmate is to get it a little drier than you might think. If it slips, try getting it a little drier. Link to comment Share on other sites More sharing options...
Andy Posted October 3, 2019 Report Share Posted October 3, 2019 When I make plates over 12 inches I can’t wire cut. The wire comes up in middle and cuts bottom of plate out.. any ideas. Tried polyurethaning bats so they were smooth and at first plates popped of when leather hard. But not after using bats a couple times? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.