Amyluvz2laughh

Hi Neil, Yes they work great. They fit perfectly in the grooves I didn’t even need pins to hold them which is good considering she’s probably a dinosaur in great shape. Thank You because I got the advice to contact Euclid’s from an older post I seen! THANK YOU!! 

Hi Neil, Yes they work great. They fit perfectly in the grooves I didn’t even need pins to hold them which is good considering she’s probably a dinosaur in great shape. Thank You because I got the advice to contact Euclid’s from an older post I seen! THANK YOU!! 

Hi Neil, Yes they work great. They fit perfectly in the grooves I didn’t even need pins to hold them which is good considering she’s probably a dinosaur in great shape. Thank You because I got the advice to contact Euclid’s from an older post I seen! THANK YOU!! 

Hi Bill, I wanted to thank you for all your help and expertise. I had the electrician come and run a fresh copper wire. I received the elements from Euclid’s and I fired yesterday and it went wonderful. I hit a 04 bisque in about 5 hours … guessing it’s the new elements plus correct voltage and power. I also added the fans going out to not pressurize heat in the garage. It went great because it was actually really chilly here in Jacksonville so I didn’t smell no toxic fumes and the room wasn’t hot. The water heater is thankfully electric and more than 6 ft from where the kiln is located and yes garage walls are block like and the floor is concrete. I’ll keep the post updated as I go but i anticipate my glaze fire will go well.  Any advice on holding heat in a manual kiln?  Anyways thank you so much , I really appreciate all the help!! 

It was a bit more pricey but I decided to pull the trigger . The 13 G had a really long wait time 4-8 weeks so I decided to accept the 14g. He didn’t say it wouldn’t last long I just questioned based on power but he said it shouldn’t effect the power. I’m excited so we shall see!!