AsHeE Posted September 26, 2015 Report Share Posted September 26, 2015 I have been doing pottery for years but am only now about to hook up my own kiln. I'm using a building that was previously a dog boarding place, so it had a washer dryer and is vented for such. Can I use this to vent my kiln? I have the envirovent 2. Thanks much! Link to comment Share on other sites More sharing options...
bciskepottery Posted September 26, 2015 Report Share Posted September 26, 2015 Yes, the dryer opening should work with your vent system. Link to comment Share on other sites More sharing options...
JLowes Posted September 27, 2015 Report Share Posted September 27, 2015 You will need to check and be sure the vent hose and through wall fitting are clear of obstructions, lint, and such. The run from the Envirovent should be kept as short as practical, with as few directional changes as you can get by with. Firing your own work is a step forward and adds a whole new aspect to making. Are you going to be making your own glazes too? Another world there too. Best luck with your installation and firing. John Link to comment Share on other sites More sharing options...
TJR Posted September 27, 2015 Report Share Posted September 27, 2015 Yoy need flexible metal piping. Do not use the plastic pipe traditionally used for dryers. Your kiln will be too hot for this. TJR. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.