Jump to content

robinelise66

Members
  • Content Count

    10
  • Joined

  • Last visited

Posts posted by robinelise66

  1. I have purchased a used Gare/Evenheat 1813 model kiln and am hoping that someone can provide some assistance with replacing the plug.

     

    The electrician came out today and couldn’t figure out how to get into the electrical box.  Are we able to just remove the red control box on the front (Kiln Sitter)?

     

    We also had a question as to what the proper amperage is.  The plate on the kiln says 240/18 but the kiln sitter shows 240 VAC – 50 AMPS.

            The Gare plate reads as follows:  Model 1813, Serial No 4.8.83, Hertz 60, volts 240, watts 4320, amperes 18, and phase is single.

            Should I hook this up to an 18 amp breaker or a 50 amp as noted by the kiln sitter?

     

    Thanks!

     

    Robin

  2. I have just purchased a new L&L kiln E-18t with the quad coils (3.9 cf)

    My old kiln was a vulcan with a kiln sitter and switches (3.2 cf)

    The new unit heats up my entire garage verses very little heat radiation of my old one when used at the same settings.

    Is it normal for these kilns to radiate this much heat externally?  

  3. Hi,

    I just received my new e18t L&L kiln and had them upgrade the controller to a gemesis touch screen.

    The literature for the dynacontrol controller (stock controller) states that the initial test firing is a slow bisque at cone 5 (not 05) and should last 12-16 hours.  

    The Genesis instructions say use a fast glaze 04 for 4 hours unless mfg says differently.

    Mfg can't seem to answer my question.  How do I program the Genysis controller for this initial firing and which firing setting should I use?  Genysis settings or dynacontrol?

    They say you must do this empty to create the oxidation needed on the bricks...

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.