Jump to content

robinelise66

Members
  • Content Count

    10
  • Joined

  • Last visited

Everything posted by robinelise66

  1. Thanks Hulk! I have an electrician coming again tomorrow so I will definitely ask that. We have a breaker for a gas dryer that we don't use, so I'm hoping he can use that. Fingers crossed!
  2. Thank you both. I guess I don't know what to do now. I don't have any other spaces available in my box, so adding a 30 amp isn't possible without a new subpanel $$$$. My other kiln takes a 50 amp. Bummed... I saw the amperage on the front panel and thought we were good. Lesson learned the hard way.
  3. I have purchased a used Gare/Evenheat 1813 model kiln and am hoping that someone can provide some assistance with replacing the plug. The electrician came out today and couldn’t figure out how to get into the electrical box. Are we able to just remove the red control box on the front (Kiln Sitter)? We also had a question as to what the proper amperage is. The plate on the kiln says 240/18 but the kiln sitter shows 240 VAC – 50 AMPS. The Gare plate reads as follows: Model 1813, Serial No 4.8.83, Hertz 60, volts 240, watts 4320, amperes 18, and phase is si
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.