Electric Kiln Questions From A Newbie
Posted 11 October 2010 - 07:35 AM
I'm new here. I've been throwing for a number of years, but always in a classroom setting. I've done a little kiln work (loading and unloading) and have fired an electric kiln, but have no experience with setting up a studio
I salvaged an electric kiln recently. I'm guessing it's at least 30 years old, but the price was right (free!). I'm not entirely certain that it works, and since it's been sitting for some time, I'm inclined to think it doesn't. The kiln is a Skutt, model 181. There is no instruction manual, though I'm trying to get one. I'm planning to fire to cone 5. The specs on the panel on it's side are as follows:
Fires to cone 6
We recently bought a house in a rural setting, and I'm in the process of setting up a studio. One of outbuildings used to house the RV of the previous owner. It is covered, and there is an outlet in which they used to power the RV. The outlet has a matching plug to the kiln, but is marked 110v/30amp. I know I need an electrician in order to make the outlet and kiln compatible, but I'd like to know a little ahead of time, before I call one! I'm ignorant when it comes to electricity... Will this be a simple conversion?
I'm also wondering if any of you could recommend a good book on electric kiln repair. I've been to Amazon, and have a couple in my shopping cart, but which would you recommend??
Posted 11 October 2010 - 09:27 AM
Posted 11 October 2010 - 03:37 PM
They know the kiln and can give you the most accurate advice.
I don't think anyone would advise you to plug it in and run it without doing this and perhaps
also involving an electrician.
Contemporary Fine Colored Porcelain
"My Artwork is strengthened by a thriving global pottery community.
In the isolation of a studio, an artist can begin to feel like an island, but in truth
we are all part of archipelagoes; chains of islands loosely connected by a stream
of information that enhances our Artwork.”
Posted 11 October 2010 - 07:19 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users