Posted 13 February 2013 - 03:12 PM
They are to look like hollow masks, from the anime Bleach. I'm using cone 10 because i need the masks to be decently strong, i'm ordering this http://kcclay.com/po...gal-bucket.html porcelain for the project. My plan is to get the porcelain, press it to the face(using straws so the nose can still breathe) and carving the shape out before removing the mask from the face.
This is the mask I'm making for myself, it should be the easiest to do(as it only covers half the face). I'm going to carve and shape it out to match, and then make the ridges for the red paint to be applied after firing. I'm not sure if i should try carving the teeth with the mask, or making them seperately and using a strong glue to attach them to the mask? And the luster of the surface is suppost to look like clean bone, not actually very shiny like most porcelain I see, I'm assuming thats from extra primers and such they add after firing, but any suggestions on getting that kind of luster? I'm also making the parts reaching upwards reach farther around the head in an attempt to not have to use a string with the mask. And I'm not sure how well the shape of the masks hold after carving but before firing, it will take a while to make all the masks and make them keep their shape, any ideas on keeping them from warping? they need to fit perfectly.
Posted 13 February 2013 - 03:39 PM
Kiln Repair Tech
Owner, Neil Estrick Gallery, LLC
Posted 13 February 2013 - 06:40 PM
A better idea - I once had a custom-made splint that was a thin, white plastic. The sheet of plastic was cut to approximate size and then softened by warming it in hot water. It was then molded to my wrist where it quickly dried and hardened. A physical therapist might be able to tell you what it is and where to buy some. It would probably give you the clean look of the mask in the picture. For what it's worth, I was told that leaving it in a hot car would cause it to soften again and flatten out. I have seen small craft items made of it, so it must be readily available.
Dry Ridge Pottery
Posted 14 February 2013 - 07:08 AM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users