Jump to content

ruthe314

Members
  • Content Count

    2
  • Joined

  • Last visited

  1. Hi Is there a formula for an ergonomically correct height for a work/wedging table? My husband just bought supplies and I'm wondering about correct height to avoid back and wrist problems.
  2. Hi, I bisqued my pots to 04, then glazed and fired them to 05. Many of them came out with pinholes. I've been reading about reglazing. Does anyone have info about doing this? Do I refire to 05 again? Or hotter? Should I soak when I reach the proper cone? If so, How long should I soak? I also have many pots that have not been glazed yet. Should I rebisque them before I glaze. I did have a problem with the power going off during firing in the initial bisque. Thanks for helping a newbie! Ruthe
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.