Jump to content

Carl54321

Members
  • Content Count

    2
  • Joined

  • Last visited

  1. Hi roberta thanks for the links. I have a hobby ceramicraft studio 1 kiln. Both the links you sent both point towards a temporary power loss but if that was the case the kiln should just work once I've cleared the message. I read the 1st link you sent before so I replaced both solonoids and the transformer and its doing exactly the same. Wondering if it is the controller itself now as I only replaced the thermocouple a few months ago. Just a lot of money to buy a new controller without knowing for sure. Thanks again for the links.
  2. Hi I'm after a bit of help. My kiln has got an error code and has stopped working. Error code when you turn the kiln on is errp. When you push start the controller goes into idol mode ready for you to start a firing schedule. When you set it to start firing it does not heat it and there are no clicks from the solonoids. Also the display shows erratic tempretures. A few links below showing videos of the problem below https://youtu.be/Mjhg263C6Ug https://youtu.be/Qup9Uj_OGr4 Any help would be appreciated as I've googled the hell out of
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.