Jump to content

Hanoverian

Members
  • Content Count

    3
  • Joined

  • Last visited

  1. Thank you all for your replies and helpful info! Joel... good idea... unfortunately, I need to apply further glazing to delicate areas after bisque fire. Otherwise, it would be great to be able to do both in one. Thanks again!
  2. Hi, I have an unfired pot (cone 5/6 clay) that has had raw Cone 6 glaze (Coyote Alabaster Satin) applied to the inside. Can I fire this raw pot at bisque temp, leaving the applied glaze inside and then fire again at Cone 6 later? I was going to once fire this pot... but thinking now it would be a better plan to bisque at least a little first since it has some fairly fragile embellishments. Hope this makes sense Thanks!
  3. Neil - could you please expound on your slower cooling schedule? "I get better results from a slower cooling rather than a soak going up." Also.. I'm not very familiar with how glaze ingredients are effected by soak vs higher temp. You mentioned that some glazes didn't mature or had altered color. Did you find specific types of glazes or certain glaze ingredients that didn't do well with the soak technique? Any info is greatly appreciated! KB Portland, OR
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.