bcw
-
Posts
2 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Posts posted by bcw
-
-
Hello,
It has been a while since our wheel stopped functioning. It was fixed last week.
The schematic diagram mentioned in the previous posts is not quite the same as ours.
I have attached our diagram.The issue we had is that the protection switch kicked in after a few turns of the wheel.
It turned out that the cause of this was a failed capacitor in the field circuit. This capacitor shorted out, causing a resistor to burn and a fuse to blow.
Even without field current there is some remanent magnetic field, and the armature could still turn. However, because the field is weak, the armature current was high. This caused the tripping of the safety breaker.We replaced all capacitors, the burnt resistor and replaced the fuse. The wheel works fine now.
Ben
Podmore pottery wheel electrical drawing needed
in Equipment Use and Repair
Posted
Hello,
Indeed, both items on the right hand side like like reed relays. The right on is marked as such - RR1. I asked a friend who is more into electronics than I am - he was wondering if this was an original attribute of the board, or a later addition. Also (unlike the relay on the right) it requires a high current to trigger.
Do you know something of the history of this wheel?
Do keep us posted, please.
Ben