I have been using Mayco Fundamentals with a clear coat for about 3 years. Yesterday I had a full load, used the same settings I always use, with the only difference being I have started to use an external fan on the controller board (on the external heat sinks) because I've had two glaze loads this summer that shut down because my kiln board reached 180 degrees. All pieces came out fine except for 3, which have no glaze on them.
Do you know why this would happen? I've attached a photo of one of the pieces where there is no glaze left. It was glazed the same as the other two chickens. I've examined it carefully, there is no glaze anywhere, not even in the recesses. There were about 6 pieces each on two levels. All but 3 of the 12 came out fine. The 3 that lost their glaze were on the top shelf. But the others on the top shelf are fine. Thanks for you help.