wvcasper1 Posted March 19, 2016 Report Share Posted March 19, 2016 Hello, I feel kinda of goofy for asking but I got this Cress kiln free. But I am used to my Duncan kiln. This cress has 5 knobs on it 3 on the top and 2 on the bottom. How do you set these for low,medium and high.? I am doing a trial now and hope it turns out ok. I used 10 for low 50 for medium and 90 for high is this correct? I needed a bigger kiln and found this one any help would be appreciated. Brenda Link to comment Share on other sites More sharing options...
neilestrick Posted March 19, 2016 Report Share Posted March 19, 2016 Yep, just treat the numbers like low-med-high. High should be the highest possible setting. Link to comment Share on other sites More sharing options...
wvcasper1 Posted October 29, 2017 Author Report Share Posted October 29, 2017 Thank you for the help! Greatly apprieciated. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.