SierraRed18
-
Posts
8 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Posts posted by SierraRed18
-
-
-
-
Kk then there’s 3 holes on the side I’m wondering if they need need to be plugged with the peep hole plugs? Or do I leave them open?
-
On 2/9/2024 at 8:24 PM, Hulk said:
Hi Sierra, welcome to the Forum!
Is there an information plate on the kiln - model and serial numbers, brand/maker, voltage and amperage requirements?
If so, please post a close up image of the info plate.
While you're at it, a pic of the inside also?That hole in the lid seems, err, too big!
Perhaps it had been fired with a baffle over most of that hole?Do you think I can just put a fire brick over the hole when I fire?
-
Shoot my picture isn’t showing very clear but it’s
240VAC, 60HZ, 1PH
KL24120, 9600 WATTS
serial number 102
-
19 hours ago, Hulk said:
Hi Sierra, welcome to the Forum!
Is there an information plate on the kiln - model and serial numbers, brand/maker, voltage and amperage requirements?
If so, please post a close up image of the info plate.
While you're at it, a pic of the inside also?That hole in the lid seems, err, too big!
Perhaps it had been fired with a baffle over most of that hole?This is the inside of the kiln and the plate
-
How to use this kiln
in Equipment Use and Repair
Posted
I’m just learning right now! I’m hoping to fire to cone 6 if that’s possible!