I have a Econo Model KR23.
220 V 3 full sections with jumper cables
I have just rewired the whole kiln and I am very new at this.
new switches, new jumper cables, new wire, and one new element(because one was broken).
I am doing the glow test and turning all switches on high, but for each section I only get the bottom element to glow (I have 6 elements in total and only 3 are glowing)
I know it's getting enough Volts from the plug, and there's continuity to the other sections.
is there anything I can check to get these elements working?
Thanks!