So, I've been working with clay for a few years now and my old Duncan kiln hadn't failed me yet... until now. I haven't fired her up all winter, and decided to do a (low fire) bisque fire of some pieces I'd made a month ago. Took longer than usual (3x) because I think my bottom switch is going out (have to fiddle with it to keep it on). Bisque was successfully fired to cone 04.
So here I am ready to glaze fire. I load the kiln as usual... some stuff on the bottom, some stuff on the top shelf. Ready to fire to cone 05. I go about my usual firing schedule, while assuming that I'll need to add some time to the high fire due to my experience with my bisque fire (I'm thinking I need to replace elements). And when I check the kiln I notice that it shut off after being on high for 2 hours. So I'm a little nervous... that seems pretty quick, my normal schedule it's on high for 4.... I wait 24 hours to unload. Open the lid, top shelf pieces look great! But I lift the top shelf and to my dismay, everything on the bottom is ruined. The glaze shivered so bad that it had all but completely fallen off every piece.
So here's my question. What the hell happened? Is it my wonky switch messing with the bottom keeping consistent heat? Is it issues with elements? I called a local ceramics store and they said that I needed to buy new glaze as they weren't compatible with my clay... but the ware and glaze in the bottom and top of the shelf were the same. They had no answer when I told them this. So I'm hoping someone out there might have an idea?
Duncan model: DK 820-2 240v single phase
Sitter: LT 3k