Jump to content

Laser Decal Help

Recommended Posts

I am firing some work that is glazed cone 6 on the inside with just colored slips and an oxide wash on the outside i need to fire to cone six and was hoping to put the decal on the colored slips during this firing if i do a thin glaze wash or 3124 wash could i put the decal on top so it has some flux to adhere it or could i put the decal on and thin wash over it. The image is not detailed but i dont want it to rub off or fire out.

Thank you


Link to post
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.