Jump to content

Cone 6 White slip Without Ball Clay?


SmartsyArtsy

Recommended Posts

Well, I did not have my glaze calc software with me yesterday and just figured that the ball clay is higher in silica than is EPK so that's why I increased the silica. But now, looking at other recipes, the Alumina/Silica amounts are all over the place with wide variations in ratio so now I'm very confused. Also, the Boron varies a great deal.

 

I just want to mix a batch to use on greenware, fire bisque and then fire cone 5.

Link to post
Share on other sites
Guest JBaymore

Are you considering that you could lose a whole kiln load because of this slip? I am a big fan of trying stuff, but I like the odds to be somewhat in my favor. You might be better off waiting until you feel confident about the slip you are using.

 

Very wise advice from a seasoned professional. I'd take it. wink.gif

 

best,

 

................john

Link to post
Share on other sites

Are you considering that you could lose a whole kiln load because of this slip? I am a big fan of trying stuff, but I like the odds to be somewhat in my favor.

You might be better off waiting until you feel confident about the slip you are using.

 

 

 

I am having a kid's workshop tomorrow and wanted to make a batch. I just took some of my recycled clay body and added frit 3124 and Zircopax. Should be fine. Sometimes I get fixated on a question and don't see what's right in front of me!!

 

Thanks everyone

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.