Search the Community
Showing results for tags 'vent master'.
Hi all, So I'm a bit new to the downdraft vent game and have a question. I was advised to drill two 1/4" holes in bottom, and lid. It probably wasn't needed to drill into the lid because i have an older skutt and i know it's not vacuum tight. But I have it all hooked up proper and it draws a flame through each hole in the lid (when kiln is off). My question is (and this may be obvious) but as the kiln is on and reaching around 1000 f, heat is obviously rising and my little lid holes seem to be blowing out heat as opposed to sucking in? Is this completely normal? Can I assume my vent is still sucking in room air through those lid holes and mixing? Or am I just blowing out heat and fumes? Thanks!