Search the Community
Showing results for tags 'sawdust'.
-
Hey guys, so tomorrow I'll make a kiln with oil can (yes it's already washed) and pit firing, I'm trying to post a pic of it but the forum sucks at uploading it, so I'll try to explain: The idea is to dig a hole on the ground where I'm going to put the fire (wood and sawdust, and yes, there's room for the oxygen to get in), then I'll put a grill over it where pieces are going to be placed, I'll also put sawdust on them with some wood, then the oil can will be put over them to isolate the heat. That's my idea, what do you guys think? Will it work? Also, there's a hole on the top of the ca
- 8 replies
-
- alternativefiring
- sawdust
-
(and 2 more)
Tagged with:
-
From the album: Black on Black Firing
-
From the album: Black on Black Firing
-
From the album: Black on Black Firing
-
From the album: Black on Black Firing
-
From the album: Black on Black Firing
-
Searched around for similar posts and only found one. So I’ve been gifted a large wooden table with a particle board top that I’ve been using for wedging. As of late lots of little bits of the particle board are getting stuck to the clay when I’m rolling out for hand building. They aren’t deeply embedded but deep enough that I’d mess up my pieces if I tried to wash them out. I’m using a sandy buff stoneware from standard ceramic (509). These pieces are going to be a bit more rustic in look so I won’t mind if there are tiny divots after firing, but my main concerns are 1) Will it negatively af
- 10 replies