Jump to content

Search the Community

Showing results for tags 'relay'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Ceramic Arts Daily Forums
    • Forum FAQ & Terms of Use
    • Studio Operations and Making Work
    • Clay and Glaze Chemistry
    • Mold Making and Slip Casting
    • Equipment Use and Repair
    • Business, Marketing, and Accounting
    • Educational Approaches and Resources
    • Aesthetic Approaches and Philosophy
    • Int'l Ceramic Artists Network (ICAN) Operations and Benefits
    • Ceramic Events of Interest
    • Community Marketplace – Buy/Sell/Trade/Free
    • Job and Career Opportunities

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 3 results

  1. Hi Melbourne friends, I am hoping someone might be able to suggest where I can get a replacement relay for my Duncan Teachers Plus kiln? I need it asap so I am hoping to find one in Melbourne, AU that I can pick up in store versus waiting for postage from interstate. Thanks
  2. I have a E-23 electric Cress kiln that stopped firing at a certain temp (1500) I did the paper test on my elements and discovered that the top two, middle two and bottom two are not heating up (all others in between heated up) I was able to do a bisque firing without fail but it stopped firing approx 1500 degrees with the E-1 error. Here is the link to the diagram if it helps- https://3fs7rd1xi6sy2zofjv3g0a0q-wpengine.netdna-ssl.com/wp-content/uploads/E23ES23ET23ETS23-208-240-VAC.pdf Thanks so much - I have several orders I am trying to complete and could really use some expert advice here Teri
  3. Hi all, first time posting. I recently aquired and olympic 1818HE with a Bartlett rtc1000 controller on it. I know the controller is made more for glass or heat treating kilns but have seen it used for ceramics without problem. I had a few error codes in my first two firings, the first was e3 during my final hold at cone 04. The code chart states that the temp fell 50* below final hold temp during the hold and the chart says that’s a relay failure. I did a full power test at r9999 to f1000 and all of the elements glowed a beautiful red. I assumed that because the kiln lives in a metal shed outside that because of a cold front that blew in that night and a peep hole being open, it was a fluke. So I loaded a glaze round and set a hold for two hours at 200 to ensure my glaze was dry before going to cone 05. The kiln then threw error code e1 saying the ramp speed was less than 12* per hour. I believe based on the amount of time between check ins, that the kiln didn’t make it above 300* I did another full power test tonight and the elements all looked great. But when the temp got to ~300* the elements all shut off and the temperature started changing between 230-310 and in between rather rapidly. The elements never turned back on but the kiln wasn’t off. Im thinking this is all a thermocouple issue but could use some advice.
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.