Search the Community
Showing results for tags 'digital controller'.
Found 1 result
-
I was sold what I thought was a cone 6 paragon kiln with a sentry 2.0 controller but after several firings realized it was only rated to cone 4. Now its of no use to me so I was hoping it would be possible to move the Sentry 2.0 digital controller over to my old cone 6 manual Cress kiln. The Cress is a 240v 20 amp kiln and the controller is coming off a 240volt 48 amp Paragon. Has anyone done something similar? I am unsure if it would be better to install a receptacle onto the controller and plug the kiln into that or wire the controller directly to the kiln. Are there any resources that might help me figure this out? Thanks' Jaalam Aiken
