Jump to content

Search the Community

Showing results for tags 'bisque schedule'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Ceramic Arts Daily Forums
    • Forum FAQ & Terms of Use
    • Studio Operations and Making Work
    • Clay and Glaze Chemistry
    • Equipment Use and Repair
    • Business, Marketing, and Accounting
    • Educational Approaches and Resources
    • Aesthetic Approaches and Philosophy
    • Int'l Ceramic Artists Network (ICAN) Operations and Benefits
    • Ceramic Events of Interest
    • Community Marketplace – Buy/Sell/Trade/Free

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hello helpful potters! I need help with an 04 bisque firing schedule. I'm having problems with pinholing in the 266 Standard Ceramic cone 4-6 dark brown clay that I'm using. About 50% of the time I'm getting a few pinholes, generally on the bottom but also on the sides. When I slow glaze, my cone 5 witnesses goes all the way down and the 6s are at about 2:00. The glaze I'm using is Potters Choice for cone 5/6, 3 coats as suggested by Amaco Brent, and this problem is happening pretty much just on the 266 and not the lighter color clays I use. I know pinholing can be a symptom of a variety of things, but I'm ready to try a slower bisque schedule in case they're being caused by gases or other impurities that haven't completely burned out during the bisque. Maybe it should go faster to 1100 and then slower for the next 1000 degrees? Or have a hold in there somewhere? I've tried to work out a schedule myself but it always ends up being about 18 hours long. Here's the cone 04 preset firing schedule I'm using in my LL kiln: 80 per hour to 250 (2 hrs) 200 per hour to 1100 (4 hours) 100 per hour to 1100 (1 hour) 180 per hour to 1676 (3 hours) 80 per hour to 1926 I also add a 10 minute hold at the end. When I use this cycle it tells me the end temp will be 1945 instead of 1926, ( 1926 is what it says on this firing schedule. It does end up at around 1945. I unplug the vent when it's done firing. Any ideas will be greatly appreciated, as would any suggestions about other things I may be doing, or not doing, that could be causing the pinholing. oh also I don't stack my bisque in the kiln. Would stilting the pieces give better air flow or deform them? Thanks! Irene
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.