Jump to content

Search the Community

Showing results for tags 'attach'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Ceramic Arts Daily Forums
    • Forum FAQ & Terms of Use
    • Studio Operations and Making Work
    • Clay and Glaze Chemistry
    • Equipment Use and Repair
    • Business, Marketing, and Accounting
    • Educational Approaches and Resources
    • Aesthetic Approaches and Philosophy
    • Int'l Ceramic Artists Network (ICAN) Operations and Benefits
    • Ceramic Events of Interest
    • Community Marketplace – Buy/Sell/Trade/Free

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 3 results

  1. I have a fully fired sculpture of a body. I need to attach the upper torso to the lower body. Each piece is about 2.5 feet high. The pieces fit together well and with balance. Thought I could use cement and clay but was told that it would not really work. Then there is extra strength epoxy. Any knowledge of suggestions would be appreciated.
  2. Hello potter community! I'm trying to figure out how to attach a chunk of antler (sustainably sourced, of course) to the side of a stein to act as the handle. I've never done anything like this before, so I'm feeling really cluless as to the best way to go about it. Currently I have two lugs coming off the stein (top and bottom) and I was thinking of fastening the handle to the mug with leather strings that tied around the lugs and the antler. I'm making them for a medieval themed event. Is there a better/more professional way to go about this? I have been unsuccessful with trying
  3. I have been making medallion mugs for a short time now. By a medallion mug, I mean: rolling out a thin slab, using a round cookie cutter to cut out a small blank medallion, stamping an image (usually a logo) into the blank medallion, attaching it to a leather hard mug. My mugs are OK, but I need to take them to the next level since I am getting some good sized orders. My main problem is getting a nice even edge around the medallion after I attach it. Any suggestions, or better yet, instruction videos out there? I have learned basically by trial and error (mostly error). I tried to post a
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.