Jump to content

Search the Community

Showing results for tags 'LT-4K'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Ceramic Arts Daily Forums
    • Forum FAQ & Terms of Use
    • Studio Operations and Making Work
    • Clay and Glaze Chemistry
    • Equipment Use and Repair
    • Business, Marketing, and Accounting
    • Educational Approaches and Resources
    • Aesthetic Approaches and Philosophy
    • Int'l Ceramic Artists Network (ICAN) Operations and Benefits
    • Ceramic Events of Interest
    • Community Marketplace – Buy/Sell/Trade/Free

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. Hi all! I found a large old AIM Kiln at a thrift store for $50 , and it looks in good condition (pics attached). Based upon the badge specs of 230v 20amps, I had an electrician install a 240v outlet on a 30amp circuit. I fired it up and everything worked for a few minutes until it shut down, and wouldn't restart. After checking continuity through all the wiring, I decided to check voltage on the outlet. Sure enough it was out of whack. I called the electrician back and he confirmed that the circuit was fried. After connecting the kiln directly to the power drop at the circuit breaker we discovered that it was pulling 45-50 amps. The electrician pointed out tiny print on the label for the Kilnsitter indicating 45 amps! So, we were both confused. Why does the badge on the control box indicate 20 amps if the Kilnsitter, which is the distribution point for electricity to all three rings, needs 45? Even if it's simply extremely deceptive labeling (which is actually indicating that EACH RING requires 20 amps) wouldn't the sitter need at least 60 amps to function? Also, almost every kiln I've seen made by almost every manufacturer has an LT Kilnsitter indicating 45 or more amps -- regardless of the amp specs for each individual model (some as low as 15 amps). Is it true that any kiln with a sitter will require wiring up a 50 amp circuit (at a cost of around $800)? And finally, why would a Kilnsitter, which is simply a heat sensitive shut-off switch, dictate amps drawn? Can anyone shed some light on this seemingly ubiquitous contradiction in specs? Thanks! Matt
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.