Search the Community
Showing results for tags 'thermocouples'.
Greetings, I am a complete newbie to kilns. We purchased a used kiln and were able to run it once successfully with a small test load. When we tried for a second load we filled her up a little more, but only 3 shelves and a couple things on each shelf. We kept getting the Err5 - Error 5 code and we would stop and start and it would continue heating up, and then code again. This was on the heating up of the kiln, not the cooling off. With what we knew and a little research, we figured the thermocouples needed replacing. One of the 3 has a crack in the cover and you can tell they are quite old.
I have an old manual L&L kiln that has an analog pyrometer, 3 thermocouples attached to a central gauge, which recently pooped out on me. I came to realize that I don't need to have them in at all times, since I only need to check the temperatures occasionally in order to turn the switches up or down. They were never really accurate anyway, since I could fiddle with the dial and the needle would fluctuate wildly, but gave me a general sense of where the kiln was. At first I looked for a digital version of the thing I was using, but then since I couldn't find one, I thought that I ma
Being a less-than-tall person, I bought an L&L 18" deep kiln - I couldn't reach the bottom of the 27â€ers. Kiln works great, tho I have to add degrees to the cone offset for 04 bisquing, and remove some from cone 6, ( according to my witness cones). Actually right now Iâ€™m using the cone 5 setting and that seems to get my 6 cone to the right spot. My e28s has 4 elements and 2 thermocouples, and this creates some challenges. I get even responses from my witness cones only if I fire with only 2 shelves. With 3 shelves in, the witness cones vary widely. Iâ€™ve tried eve