Search the Community
Showing results for tags 'error'.
Found 2 results
I have a big sale coming up this weekend and I put the last bisque load in yesterday afternoon. I come into the studio today to find the kiln reading Error 1. This is a Skutt kiln model km-1227 firing a bisque load to cone 04. This error is about the ramping up rate being less than 12 degrees per hour. Possible causes include large load which isn't the case, and issues with either the relays, elements, or voltage. Normally, I would just call the kiln repair man, but he was here in July fixing this kiln. The issue then was the electrical plug. It had some discoloration around one of the prongs, and he re-wired and replaced the whole plug section. I also had an electrician come out and check the wall wiring and outlet to make sure the problem was isolated in the kiln plug, which it was. The wall wiring is fine. The kiln has been running about twice a week since the repair just fine. The other issue is that our power had been out all morning before I turned the kiln on. Questions: 1) would a power outage cause the kiln to sense low voltage? 2) do you think the issue is with the wiring or is it just ANOTHER issue with the same kiln that happened to pop up right after the first issue? 3) Am I correct in assuming trying to re-run the kiln will result in the same error or create a bigger problem? Most importantly: 4) Will the load be underfired and need to be fired again? Or do you think it's okay to glaze? I have no idea what temp it was at when the error occured and it's still too hot to open and look at. My other kiln is doing glaze loads all week and if I need to re-fire I will not get this entire kiln load done in time for the sale. Thanks!!!