Jump to content

Mdrake

Members
  • Content Count

    5
  • Joined

  • Last visited

About Mdrake

  • Rank
    Newbie

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Ha! I would have fired that student! Thanks to all for the information generously offered.
  2. Thanks so much. These things are not covered in the operators manual...
  3. Another newby question: the wet clay is flowing haltedly out now, as a wet blob, but not enough and not the right consistency to form a nice cylinder. Is there a minimum amount of clay one must put in the hopper in order to expect it to come out the other end? In other words, can I put a small amount into the hopper and expect it to come out the other end? I realize I need to play with the consistency of the clay I put in the hopper. Thanks!
  4. Hi there. I just bought a shimpo pm-071 v and I put some pretty hard, almost leather hard clay, about 8 lbs and tried to pug it, and the clay won’t push down into the hopper (I guess it is too stiff), and when I manually push it down, it just sits in the auger area and spins. What to do? Add more clay? It won’t go down in there. Help!
  5. Hi there. I just bought a shimpo pm-071 v and I put some pretty hard, almost leather hard clay, about 8 lbs and tried to pug it, and the clay won’t push down into the hopper (I guess it is too stiff), and when I manually push it down, it just sits in the auger area and spins. What to do? Add more clay? It won’t go down in there. Help!

  6. New to this. I have a pugmill question.

    1. Mark C.

      Mark C.

      post it in the equipment section 

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.