Jump to content

Rockhopper

Members
  • Content Count

    229
  • Joined

  • Last visited

About Rockhopper

  • Rank
    Advanced Member

Profile Information

  • Location
    Southwest Ohio

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Single Status Update

See all updates by Rockhopper

  1. I have tried several times but my slip will not release from one section of the mold any ideas of what the issue is I have waited over night and it still stays in that one section

    1. Rockhopper

      Rockhopper

      Sorry - My slip-casting experience is very limited.  If you post this question in the Studio Operations and Making Work forum, I'm sure you'll get solid advise from folks that know.

    2. Mark C.

      Mark C.

      Need more info or photos than( my mold) like what is the form are there undercuts-was the plaster mold dry -has it ever worked before or is it a new mold? is the slip the right stuff. is the mold a solid one or did you drain it out at the right time.

      I could go on but more info is needed 

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.