Jump to content

Pasco Kiln Model P-6 Where To Buy New Elements


Recommended Posts

Have old Pasco p-6 kiln , bought used and elements are shot .  looked all over internet can't find anyplace that has them. it is 240 volts and 28 amps. I measured the slot and the back of the element is 1/2" beyond the face of the brick and the slot measures 1/4" vertically. there are 16 brick making up the circumfrance of the kiln and the back of the element sits 1/2 back from the face of the brick which measures 3 1/2" making where the back side of the element sits which makes each brick hold a section 3 3/4"long of the element. so 16 x 3 3/4 = 60". so the business part of the element should measure approx, 60" plus the ends being x" where it goes for the hookup. so i think what I need would be 6 elements 1/4" diameter x 60" plus x". any body able send me a link where i could purchase them

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.