Jump to content

L&l J230 Maual Kiln


Recommended Posts

I was on Craigslist and seen it last  night, still in the box wrapped in plastic and on the pallet it was delivered on.. Kiln shelf kit and vent comes with it... its a 240V and I think she told me it is a ^10 kiln..

 

$300

Im going to pick it up Saturday, cant be much wrong with it... I hope..

 

Neil where are you at ? I seen where you were behind, hope your getting caught up...

 

still building the Dragster, my blanket came in yesterday afternoon.. 50 sq. ft of 8# ...

Link to comment
Share on other sites

Gotcha, does the controller mount to more than one ring of the kiln? what tools will I need to to take it off?

 

The control box probably mounts to just one section, and there are jumper cords that connect the other sections to it. I would take both a phillips and slotted screwdriver to be safe. I would also take a pair of needle nose pliers and standard pliers as you may need them to get the hinge apart (cotter pins and such). It just depends on what year it was made as to what type of parts it will have on it. With those 4 tools you should be set though. L&L doesn't usually use any hex head screws, but if you have a set of nut drivers take them with you.

Link to comment
Share on other sites

Thanks everyone, you all are great.. We wasn't really ready to buy a E-kiln, we are rite in the middle of buying the supplies to build a Raku kiln.. Then seen this one and couldn't pass on it.. Its in a great part of town and the lady is very easy to deal with, it was her mothers kiln..

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.