joshur Posted December 7, 2016 Author Report Share Posted December 7, 2016 Hi Joe, Thanks for the very helpful information and images. I'm planning on firing a small Bailey gas kiln (cone 10) soon and will be reduction cooling it, so I am primarily interested in keeping track of the atmosphere as the kiln cools. One burner will be on low and the other other burner port will be bricked up. The damper will be all the way in. I'm aiming to keep it in reduction until about 1600F. Two quick questions: 1. You mentioned removing the sensor as soon as temp is reached. Do you forsee any problems leaving it in as the kiln cools - the whole reason that I'm using it is to keep the kiln in reduction down to 1600. Would it be too much thermal shock to the unit to insert it at the end of the firing? I do not remove the sensor, I just cover the outlet port to reduce flow through the kiln after shut off, should be no problem to leave the sensor working until total shutdown. 2. I'm going to be renting a kiln at a local craft school and will not be able to drill a whole in the back wall. Do you see any problem with inserting it through one of the spies, as long as i make sure that it is airtight? I will have the other one plugged up completely once the cones are down. Should work OK in the upper peep hole. thanks again! Link to comment Share on other sites More sharing options...
docweathers Posted December 9, 2016 Report Share Posted December 9, 2016 Here is one that I built a couple years ago for my Olympus updraft kiln. It uses a Ford oximeter. It seems to work quite well and is very simple. The whole thing can be lifted off when I'm ready to open kiln. Link to comment Share on other sites More sharing options...
Dick White Posted December 9, 2016 Report Share Posted December 9, 2016 Now that's interesting! An oxyprobe and damper in one. Link to comment Share on other sites More sharing options...
docweathers Posted December 9, 2016 Report Share Posted December 9, 2016 It keeps the gas flow over the oxyprobe and you don' have to drill you kiln Link to comment Share on other sites More sharing options...
Mark Winner Posted June 8, 2019 Report Share Posted June 8, 2019 Would it work the same installing it in a down draft Kiln at the top of the chimney? I did this years ago, and now reading your post I’m wondering if your design would be more accurate? My readings would jump up and down and I would have to average them and take the middle number. I am hoping your designe would be an improvement. Also go to a car junkyard and pull a few oxy probes for less $$. Link to comment Share on other sites More sharing options...
Bill Kielb Posted June 9, 2019 Report Share Posted June 9, 2019 On 12/8/2016 at 9:54 PM, docweathers said: Here is one that I built a couple years ago for my Olympus updraft kiln. It uses a Ford oximeter. It seems to work quite well and is very simple. The whole thing can be lifted off when I'm ready to open kiln. Your design has been the one of choice over the years. Calibration, cleaning always an issue. Augmented by sight and experience it seems to work ok. I prefer the oxyprobe, 800 bucks or less as I just buy the probe and hook to my PLC controls or multi meter. Expensive but relatively dependable and repeatable. The PLC provides a nice graphic display and looks cool. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.