cfsarver Posted November 25, 2013 Report Share Posted November 25, 2013 I have a glaze recipe that specifys a viscosity of '45 to 48' to use. My hydrometer is in increments of 2.000 up to top number of 1.000. Is the recipe asking for a viscosity of 1.45 to 1.48? Perhaps I need to go back to the source and check if it's printed correctly. I don't assume things these days. Thanks to all you smart people out there. Link to comment Share on other sites More sharing options...
Guest JBaymore Posted November 26, 2013 Report Share Posted November 26, 2013 I have my students make "relative" viscometers. This tends to be more accurate for most ceramic glazes than the specific gravity done with a commercial or home-made hydormeter. While you can't "compare numbers" with others with this unit.... for you own glaze work from btach to batch it is pretty darn accurate. Take a small metal or plastic can/container...... about the size of a Campbell's soup can. Drill a 1/4 inch to 3/8 inch hole in the center of the bottom. (Start with 1/4" ... and if you find objectionally long timing for how you like you glazes.... increase hole size slightly.) Use a felt tip marker to draw a "fill to line" on the inside of the can. Take a glaze that is already exactly the consistency you want for application...... and fill the can to the line with your finger over the hole. Pop your finger off the hole and time how long it takes to empty (most digital watches have a stopwatch function these days). Record this # with your glaze recipe. When you mix new batches of that glaze,..... carefully adjust the water content until the drain time matches. best, ..............john Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.