Jump to content


Photo
- - - - -

Replacing EnviroVent 2 motor


  • Please log in to reply
3 replies to this topic

#1 jemenfous5

jemenfous5

    Member

  • Members
  • PipPip
  • 10 posts

Posted 24 February 2013 - 05:31 PM

I believe I need to replace the motor in my EnviroVent 2 system. I read on here that it can be replaced with a generic motor. Does anyone have a link to an appropriate motor?

#2 neilestrick

neilestrick

    Neil Estrick

  • Members
  • PipPipPip
  • 2,848 posts
  • LocationGrayslake, IL

Posted 25 February 2013 - 01:35 PM

The motor on the vent should have a serial plate with a model number. Otherwise, look for a motor with the same CFM rating and mounting plate size. It's a 140 CFM shaded pole blower. Dayton and other companies make them. I should be able to get you a part number when I'm back at my shop later. I think I paid about $75 for the last one I bought.

Neil Estrick
Kiln Repair Tech
L&L Kilns Distributor
Owner, Neil Estrick Gallery, LLC
www.neilestrickgallery.com

neil@neilestrickgallery.com


#3 neilestrick

neilestrick

    Neil Estrick

  • Members
  • PipPipPip
  • 2,848 posts
  • LocationGrayslake, IL

Posted 25 February 2013 - 03:56 PM

HERE is the motor we use on the L&L Vents. Should be the the same or at least very similar. Check the size of the mounting flange to be sure.

Neil Estrick
Kiln Repair Tech
L&L Kilns Distributor
Owner, Neil Estrick Gallery, LLC
www.neilestrickgallery.com

neil@neilestrickgallery.com


#4 firerobinpotter

firerobinpotter

    Newbie

  • Members
  • Pip
  • 4 posts

Posted 17 September 2013 - 03:56 PM

Jemenfous5,

 

I, too, need to replace my EnviroVent 2 motor. Do you recall what you ended up purchasing? Was it a simple change over and does it work well?

 

Thanks!
Michael 

 






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users