Jump to content

Paragon intake holes


Recommended Posts

I am trying to set up my Orton vent master on my new Paragon TNF823,big ceramic stores biggest little kiln.My husband is helping me and instructions are saying drill intake holes in the lid.I'm thinking they are pre drilled but can't see them.Really do not want to screw up my 1st kiln.Do we need to drill or not?

Link to comment
Share on other sites

paradise, if youre not sure about the holes, turn out the lights in the room and get your hubby to shine a flashlight on the lid while you stand on other side and see if any light passes. normally the lids are not predrilled due to the fact that not everyone gets a vent master. it usually calls for 4 small holes to be drilled 90 degrees from each other in the top lid. sometimes comes with a template. good luck. j.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.