Jump to content
Wyatt

Wiring Harness for Paragon Kiln

Recommended Posts

Hi,

I have a Paragon TNF-823 Kiln with a Sentry 2.0 Controller. The kiln mechanic is instructing me to purchase a 'wiring harness' for the controller which he will then install. He describes what I need as "all of the wiring inside the controller". When I call distributors they do not seem clear that this is what they can sell me. Can anyone direct me in the right direction of where I can purchase this? Thanks!

Share this post


Link to post
Share on other sites
On 6/12/2019 at 3:27 PM, Wyatt said:

Hi,

I have a Paragon TNF-823 Kiln with a Sentry 2.0 Controller. The kiln mechanic is instructing me to purchase a 'wiring harness' for the controller which he will then install. He describes what I need as "all of the wiring inside the controller". When I call distributors they do not seem clear that this is what they can sell me. Can anyone direct me in the right direction of where I can purchase this? Thanks!

There is a nine conductor 22 gauge low voltage harness from the controller. Pretty rare for it to fail but I guess one of the circuit board mating plugs could have. The rest of the wiring can be repaired or replaced with normal high temp stuff. I am curious to see a picture of what failed. Paragon is very accessible, see below.

318D76D7-9CF5-42E2-9061-400A4DC7B3BD.png

54C88199-E756-40D9-AACF-F22E6563CB52.jpeg

Edited by Bill Kielb

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.