Jump to content

Efflorescence On Plaster Wedging Board


Saki

Recommended Posts

I have been using a plaster wedging board made from #1 pottery plaster for about 6 months with no problem. Recently, I started noticing white, fluffy salt deposits on the surface. Some photos are attached.

 

It seems to be worse after I reprocess a batch of clay from slip. (By reprocess, I mean recycle dry clay trimmings by adding water to them, forming a chunky slip, and then scooping the slip onto the plaster, where it dries into plastic clay that is workable for throwing again.)

 

Since this only started happening recently, I suspect it is not "primary" efflorescence from calcium deposits in the plaster board, but rather "secondary" efflorescence from calcium that has dissolved into the water in the slip. From what I understand, the salts are left behind on the surface when the water that has been absorbed by the plaster evaporates into the air. I am using Standard Ceramic 365 English Porcelain for Cone 6.

 

I have been wiping the surface of the plaster clean with a dry brush and shammy, but I am concerned the efflorescence may be damaging the wedging board. I am also concerned that it may have an effect on clay that I re-wedge there. Are these valid concerns? If so, are there any remedial steps I should take to minimize the damage?

 

Thank you.

post-76879-0-95180700-1480443527_thumb.jpg

post-76879-0-76813300-1480443542_thumb.jpg

Link to comment
Share on other sites

Thanks everyone. I'm relieved to learn this isn't harmful.

 

Chilly, I think that's consistent with my experience, too. I didn't notice this in the summer, only after the weather started to get wet.

 

Nerd, Sounds like a delicious recipe  :D

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.