oldlady Posted November 23, 2015 Report Share Posted November 23, 2015 doc weathers recently built a vacuum into his pugmill. i just spotted a venco part on potterbarter in new bern, nc. i never realized parts could be taken off or added, why would someone take it off? i understand adding one but cannot figure why removing one is desirable. Link to comment Share on other sites More sharing options...
Mark C. Posted November 24, 2015 Report Share Posted November 24, 2015 This motor is 220 volts-made in 1997 in Australia-just stating facts here. I just looked it up. Mark Link to comment Share on other sites More sharing options...
ronfire Posted November 24, 2015 Report Share Posted November 24, 2015 I did a little vacuum bagging with epoxy resin and used a composer from a fridge. I am sure you could adapt one onto a pug mill. The fridge compressor develops a fair amount of vacuum but does not have a large volume of flow. The nice thing is you can get then for free with some scrounging. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.